Quick win
Vacuum Hose Connector and Hose Mender
Join two hoses, or save a torn one.
- Joins two hose ends into one.
- Fixes a torn hose without buying a new one.
- Ribbed grip rings hold the hose on.
- Straight through bore keeps the airflow strong.
Ships printed to order, ready to use.
- Made to fit your toolFriction fit, no clamps
- Made in the USAPrinted to order
- Flat $7.95 shippingOne rate, anywhere in the US
- PETG, not brittle PLABuilt for the shop
About This Part
A short barrel that slips inside two hose ends and ties them together. Push one hose on each side until it meets the middle. The ribbed grip rings bite so it holds. Add a hose clamp if you want it permanent.
It fixes a torn hose too. Cut out the bad spot, then splice the two good ends back together for a few bucks instead of buying a whole new hose.
The bore runs straight through, so it does not choke your suction.
Who it is for: Anyone with a shop vac or dust hose that split, cracked, or came apart.
Specs
Vacuum Hose Connector FAQ
How does the hose connector work?+
It slides inside two hose ends. Push a hose onto each side until both meet in the middle. The grip rings hold them so the joint stays tight. Add a hose clamp over each end for a permanent joint.
Can it fix a torn hose?+
Yes. Cut out the torn part, then push the two good ends onto the connector. You get your hose back for a few bucks instead of buying a new one.
Will it fit my hose?+
The standard size fits a 2-1/2 inch hose inside diameter. Shop hoses vary, so tell us your size and we print it to match.
